Typically, the corresponding circuit breaker will trip when an electrical fault occurs in your house. This will cut off the flow of current immediately. The main switch might trip as well. This leaves your entire house without electricity.

If you want to guarantee the safety of your loved ones and property, it’s important that you know how to determine the source of an electrical fault after a power outage. It can result in severe consequences if you choose to ignore the problem.

Today, we’re going to share with you some tips on how to determine electrical faults in your house. If you need help, you can always hire a professional electrician Huntington Beach.

Make Sure You’re Safe

First of all, you need to make sure you’re safe before you find any electrical fault. You’ve got to guarantee you installed every single electrical product in your house to meet the building regulations of your area.

Here are a couple of things you need to do before you begin any electrical work:

  • Use a voltage meter to test for lighting circuits. Use a socket tester to check if your circuit is dead.
  • Create a note and attach it next to the fuse box to tell others you’re planning to work on it.
  • If possible, turn off the breaker and lock it.

How To Deal with Faulty Wall Lights or Ceiling

If you notice that one light isn’t working, you need to examine all other lights on the same circuit. You have a dead circuit of all other lights aren’t working.

You might only have a faulty bulb if the other lights within the circuit are working properly. You can install a new bulb.

If the new bulb is still not working, shut down the power and examine every flex connection and cable at the light. Use a continuity tester to examine the condition of the flex.

If you can’t find the problem, hire a professional electrician.

How to Deal with Dead Circuits

Unplug every appliance and turn off every light connected to the circuit if you’ve got a dead circuit. Shut down the main switch at the fuse box. Then, repair the circuit fuse or reset the circuit breaker. Next, turn on the main switch.

Turn on every light and appliance within the circuit to figure out which device is tripping the breaker.

You might have faulty wiring if the fuse blows or the breaker trips again. Only a professional can handle this problem.

Inspecting Appliances

First, you have to inspect if one of your plug-in appliances is not working. For those who don’t know, faulty plug-in appliances are one of the most common reasons for electrical faults.

Try to plug the appliance into a different socket. If it works, you know that the original socket is probably dead and you have to replace it. If it still does not work, try to plug the appliance into another circuit. It’s preferable to use the circuit from another floor. You’re dealing with a dead circuit if your appliance works.